Get Price or Support

  • small hydraulic jacks

    Bonded Multistrand Post-Tensioning | STRUCTURAL …

    GROUTING OF BRIDGE POST-TENSIONING TENDONS TRAINING MANUAL ... They typically consist of an anchor head (or wedge plate) and wedges, bearing plate, duct transition (or trumpet) and grout tube connection (see ... The duct is the sheath for the PT strand or bar. Because oftendon geometry and profile restrictions, the duct must be accurately ...

  • tipper trailer Power Unit

    Enclosed Spring Grip Anchor for Prestressed Concrete

    Precast Equipment Foundations; Structural Strengthening; Bonded Multistrand Post-Tensioning ... A single multistrand tendon can hold up to fifty-five 0.5″ or 0.6″ strands encased in PT-Plus™ plastic or steel duct and is fully bonded using a high-performance grout. ... Placing of anchor head and wedges. 2) Positioning of jack. 3) Stressing ...

  • fixed hydraulic scissor lifting platform hydraulic cylinder

    Equipment and Systems for Stressing Wire and Strand in

    This bridge is a 19,265 foot long precast segmental box girder bridge, built by the ... the strand and wedge directly out the back of the anchor where the worker is positioned. ... DETENSIONING AN EXTERNAL BRIDGE PRESTRESSING TENDON ...

  • center hole jack

    Post tensioning strand Manufacturers & Suppliers, China

    Enclosed Spring Grip Anchor for Prestressed Concrete Introduction of Spring Loaded Anchors Spring Loaded Anchors (SLA’s) are generally used at the

  • hydraulic ram jack

    SPLICE CHUCK – ONE TIME USE - Meadow Burke

    Notching of the strand by the wedges and an ... chorage systems is critical to the design is precast concrete structures designed for seismic resilience. Instead of the ... is possible that anchor manufacturers conduct anchorage validation tests, but the results of these tests are typically

  • double acting hollow cylinder

    Pre-stressing Accessories | Ancon New Zealand

    Stressing Anchors / Grips / Wedges We offer a full range of stressing grips for all pre-stressed concrete applications from 5mm wire up to 12.7mm strand.

  • 10 ton hydraulic jack price

    Prestressed concrete - Wikipedia

    Monostrand PT systems: Coated strand Coated anchors Encapsulation accessories Wedges Coated Anchor Grease Cap Coated Strand Lockable Sleeve Wedge. UNBONDED PT COATED STRAND The process of coating the strand is called extrusion Coated strand 7-wire PC strand: ultimate

  • hydraulic cylinders for dump trucks

    Wire/Strand Slippage—A Potential Failure Mode for Post

    post tensioning strand manufacturer/supplier, China post tensioning strand manufacturer & factory list, find qualified Chinese post tensioning strand manufacturers, suppliers, factories, exporters & wholesalers quickly on Made-in-China.com.

  • hydraulic trailer jack

    Anchorage Types - DSI USA

    Sure-Lock® Splice Chuck – One Time Use assembly includes the body, threaded end caps, spring spacer and two-piece wedges with wire rings. Refer to the table for strand size and item number.

  • self-locking hydraulic jack

    Cable Anchor Price, China Cable Anchor - made-in …

    Utility Anchor Selecting the Proper Insert Lifting System Fleet-Lift System Swift Lift System ... Prestress Strand Restraining Devices and Accessories Utility Anchor Lifting System Fleet-Lift System ... In the continuous development of hardware for the precast industry, Dayton Superior places great emphasis on ensuring that material

  • hydraulic dump truck with lifting eye

    Post Tensioning Chucks - Prestress Supply

    including slab-on ground, elevated slab, precast bridges and structures, and underground mines. 3 ... They can also be used in other bare anchor mono-strand applications such as barrier cable installations. ... Anchor, wedge length and

  • DC12V 24V tipper trailer Power Unit

    Glossary of prestressed concrete terms - Wikipedia

    2.1.2 Strand –Coated 11 PT Coating or Tendon Grease ... 2.2 Anchor, Wedges, Pocket Former 12 ... and details for post-tensioned concrete installation.

  • Hydraulic Pistons Prices

    PCI Journal - WIN 2012

    end of precast girder 10'-0" (typ.) 1'-6" 1'-6" ¢ anchor plate ¢ gir. ¢ gir. ... ¡ ¾" x 1'-4"ø astm a36 anchor plate prestressing strands 2" min. spa. (typ. ~ not tensioned) 2¾"ø x 1Â" steel strand anchor. anchor strand with two piece wedges after girder erection. verify wedges are seated tightly immediately before placing diaphragm ...

  • hydraulic ram for trailer and dump truck

    System Description - DSI USA

    Ext PT Strengthening Applications Limited: ... Wedges and wedge plate Nut and washer PT Anchorages External PT Anchorages External. STRUCTURAL 5 PT Tendons Deviator Block Dead end Anchor Joist ... Strengthening of Precast Double T Strengthening of Precast Double T Flexural Strengthening

  • pneumatic valve AW30-02-A smc internet

    Repair to Anchor | Prestressed Concrete | Concrete

    2¾"ø x 1Â" steel strand anchor. anchor strand with two piece wedges before girder erection. verify wedges are seated tightly immediately before placing diaphragm concrete 2" x 2" x 2½" recess for strand detensioning (typ.) [½"ø or 0.6"ø] strand in ... strand in plastic sleeve (typ.) pt anchor plate to be installed perpendicular to top of ...

  • 100t hydraulic jack

    Repairs to Prestressed Strands in Double-Tee Stems

    The wedges are made up of two segments for use with wire and three for use with strand. Double-ended joints DEJ/DEJ reducers can be used to connect wire/strand together midspan.

  • Triplex Piston Single-Acting Mud Pump (BW-150)

    Wedges And Barrels - Anchor Head Manufacturer from Surat

    Wire/Strand Slippage—A Potential Failure Mode for Post-Tensioning Tendons. ... tendons on a large structure revealed relatively advanced levels of strand corrosion within and inboard of the end anchors. Strand corrosion within anchors was so advanced that wires had disengaged from the wedges, resulting in slip, contraction, and consequent ...

  • 1000ton hydraulic jack

    Effects of Anchor Wedge Dimensional Parameters on Post‐ Tensioning Strand Performance Kevin Q. Walsh, Randy L. Draginis, Richard M. Estes, and Yahya C. Kurama

  • Synchronous moving hydraulic jack

    Strand Post-Tensioning System; Anchorage Types; Multistrand Post-Tensioning System. Available Anchorage Types. ... The wedge plate and the conical anchor body with usually three load transfer planes introduces the prestressing force continuously into the member with minimal front area. The separation of anchor body and wedge plate makes it ...

  • original pneumatic smc air pressure regulator factory new

    Precast Post-tensioned Concrete Structures Amazing Facts About Us ... Anchor pocket with single strand tendon & wedge set 6 ENCAPSULATED PT SYSTEM grease-filled cap o-ring wedges steel strand encapsulated anchor seamless plastic duct S˚˛˚˝-ˆˇ-˚˘˝-A ˚ T˝ ˘ ˆ ˆ

  • hydraulic jack for strutting beams

    Wedge Anchor Steel Cable Prestressed Anchorage Anchor Anchor Chain Cable Anchor Clamp Cable Price Wedge Cable Price Pump More 7,991 products found from 249

  • Heavy Equipment Large Custom Hydraulic Cylinder

    Post-Tensioning Chucks Our post-tensioning chucks are manufactured under strict tolerances and quality control and meet or exceed the requirements of the Post-Tension Institute and International Building Code. Chuck sizes include .600″, 1/2″, 7/16″ and 3/8″ . All post-tension chucks come with a two-piece wedge. Three-piece wedges are available upon request.

  • Dump hydraulic telescopic ram for crane

    Glossary of prestressed concrete terms Jump to ... and that transfers the strand force to the anchor via tapered wedges located within its internal conical recess. A set of barrels can be used with a mono-strand stressed tendon as an alternative to an anchor block. ... commonly used when joining precast concrete segments in a prestressed ...

  • hollow jack

    Table 2 lists the tested wedges, which are named ac- cording to the number of wedge pieces (2P for two-piece wedges or 3P for three-piece wedges) and the nominal strand …

  • compact cylinder AFD20-02-A smc internet

    Monostrand Post-Tensioning System The strength, ... DYWIDAG Strand Anchor Systems. System Description; DYWIDAG Temporary Strand Anchors; ... The DYWIDAG Wedge-Anchor System exceeds ACI Code requirements for guaranteed ultimate capacity of the tendon, and seating losses are reduced to a minimum by the two-piece wedge design. ...

  • Front end loader hydraulic cylidner/ram

    Repair to Anchor - Download as PDF File (.pdf), Text File (.txt) or read online. post tensioning anchor repair ... Typical strand properties are as follows: ASTM A416 LOW RELAXATION, GRADE 270 S PECIFICATION ... A protective plastic cap is installed with grease over the anchor end where the seated wedges rest. NSPE. The existing anchor may be ...

  • Small electric hydraulic jack

    GRABB-IT Cable Splice Installation Instructions Required Equipment: 1) GRABB-IT Cable Splice assembly and Chuck Splice ... Push strand through Anchor Bodies until the strands touches the end of the Threaded Rod. ... Slide wedges on strand to 48mm from end of strand Strand marked with tape Anchor Body (Keep loose on strand) ...

  • 1500ton hydraulic jack

    Repairs to Prestressed Strands in Double-Tee Stems. Sep, 2013 ... A new repair method was implemented to restore the structural integrity of precast double-tee stems that have lost their prestressing strands due to physical damage or corrosion. ... It grabs the ends of strands with anchors and standard prestressing wedges, and then pulls the ...

  • double acting jack

    Wedges And Barrels Offering you a complete choice of products which include Anchor Head, Prestressed Anchor Wedges And Stand, Post Tension Anchor Master Wedges 15.7 MMand 15.24mm, Wedges 15.24 MM Strand, Anchor Wedge Strand and Prestressed Tensioned Pt Sleb Master Wedges 15.7 Mm Strand.